Scheppach 5906151901, Перевод оригинального руководства пользователя

Страница: 27 / 88

www.scheppach.com
GB | 27
13. Troubleshooting
Fault Possible cause Remedy
Compressor does not
run.
Mains voltage not present. Check cable, mains plug, fuse and socket.
Mains voltage too low.
Avoid extension cables that are too long. Use
extension cables with sufficient conductor
cross-section.
Outdoor temperature too low.
Never operate with an outside temperature of
below 0° C.
Motor overheating.
Let the motor cool down, if necessary, eliminate
the cause of overheating.
Compressor runs, but no
pressure.
Non-return valve leaking Replace the non-return valve.
Seals defective.
Replace the seals, have defective seals
replaced at a specialist workshop.
Drain screw for condensate leaking.
Tighten the screw by hand. Check the seal on
the screw and replace if necessary.
Compressor running,
pressure shown on the
manometer, but tools are
not running.
Hose connections leaking.
Check compressed air hose and tools, replace
if necessary.
Quick-coupler leaking. Check quick coupling, replace if necessary.
Pressure set too low at pressure
regulator.
Turn up the pressure regulator further.