www.scheppach.com
56 | GB
By properly disposing of this product, you are also contributing to the effective use of nat
-
ural resources. You can obtain information on collection points for waste equipment from
your municipal administration, public waste disposal authority, an authorised body for the
disposal of waste electrical and electronic equipment or your waste disposal company.
13. Troubleshooting
Fault
Possible cause
Remedy
The compressor does
not start.
No supply voltage.
Check the supply voltage, the
power plug and the socket-out-
let.
Insufficient supply voltage.
Make sure that the extension
cable is not too long. Use an
extension cable with large
enough wires.
Outside temperature is too low. Never operate with an outside
temperature of below +5° C.
Motor is overheated.
Allow the motor to cool down. If
necessary, remedy the cause
of the overheating.
The compressor
starts but there is no
pressure.
The non-return valve leaks.
Have a service center replace
the non-return valve.
The seals are damaged.
Check the seals and have any
damaged seals replaced by a
service center.
The drain plug for condensa-
tion water (11) leaks.
Tighten the screw by hand.
Check the seal on the screw
and replace if necessary.
The compressor
starts, pressure is
shown on the pressure
gauge, but the tools
do not start.
The hose connections have a
leak.
Check the compressed air
hose and tools and replace if
necessary.
A quick-lock coupling has a
leak.
Check the quick-lock coupling
and replace if necessary.
Insufficient pressure set on the
pressure regulator (3).
Increase the set pressure with
the pressure regulator.
