29
GB
The machine must never be operated by more
than one operator.
•
Never attempt to split any trunks which are larger
than the recommended trunk capacity.
•
The trunks must be free of any nails or wire which
may be flung out or might damage the machine dur
-
ing operation.
•
The trunks must be cut flat at the ends and have
had all branches removed from them.
•
The wood must always be split along the direction
of the grain. Never insert the piece of wood cross
-
wise to the splitter and then attempt to split it as this
could damage the splitter
•
The operator must operate the machine controls
with both hands and must not use any other kind of
device as a substitute for the controls.
•
The machine may be operated only by adults who
have read the operating instructions prior to start
-
ing operation. No one is permitted to use the ma
-
chine without reading the manual first.
•
Never attempt to split two trunks in a single opera
-
tion as this may cause pieces of wood to be flung
out, which is dangerous.
•
Never add more wood or replace a piece of wood
while the machine is in the middle of an operation
as this would be extremely dangerous.
•
All persons and animals must be kept at least 5 me
-
ters from the machine while it is working.
•
Never modify the protective equipment on the
wood splitter or carry out any work without such
equipment attached.
•
Never attempt to force the wood splitter to split
excessively hard pieces of wood under cylinder
pressure for more than 5 seconds. Overheated oil
under pressure may cause damage to the machine.
Stop the machine, turn the trunk through 90° and
then try to split it again. If the wood still fails to split
this means that it is too hard for the capacity of the
machine and must be removed to avoid damaging
the wood splitter.
•
Never leave the machine unattended while running.
Stop the machine and unplug the power plug when
-
ever you are not using it.
•
Never use the machine near natural gas, petrol
channels or other inflammable materials.
•
Never open the control box or the motor cover. If
necessary, contact a qualified electrician.
•
Make sure that the machine and the cable never
come into contact with water. Handle the power
cable with care and never pull or tug it with a jolt
to unplug it. Keep all cables away from excessive
heat, oil and sharp-edged objects.
•
Please take note of the temperature conditions
whilst you work. Extremely low and extremely high
ambient temperatures may cause malfunctions.
•
Before using the wood splitter for the first time,
users should be given practical training by an ex
-
perienced operator and should initially work with it
under supervision.
Before starting work check the following
• Do all the functions of the tool function correctly?
•
Does all the safety equipment function correctly
(two-handed safety switch, ON/OFF switch)?
•
Can the tool be switched off correctly?
•
Is the tool adjusted correctly (truck support, trunk
holding plates, splitter height)?
Keep the working area free of obstructions (for exam
-
ple pieces of wood) whilst working.
SPECIAL WARNINGS RELATING TO THE USE OF
THE WOOD SPLITTER
Special types of danger can arise during the use of
this powerful machine. Take particular care to protect
both yourself and all other persons in the vicinity.
Hydraulic system
Never use the machine if there is ever any danger
from hydraulic fluid. Check for leaks in the hydraulic
system every time before you start using the machine.
Check that the machine and your work area are
clean and free of any patches of oil: Hydraulic fluid
may be the cause of danger because it can cause
you to slip and fall, may make your hands slip while
operating the machine or may cause a fire.
Electrical safety
•
Never use the machine if there is any risk of an
electrical hazard.
•
Never use an electrical device in moist conditions.
•
Never use this machine with an unsuitable cable
or extension cable. Never use this machine if you
are not connected to a properly earthed connection
which provides the power required as specified on
the label and is protected by a 16 amp fuse.
Mechanical hazards
Wood splitting is associated with particular mechani
-
cal hazards.
•
Never use this machine if you are not wearing prop
-
er safety gloves, shoes with steel caps and certified
eye protection.
•
Be cautious of splinters generated while working;
avoid stab-like injuries and the possibility of the
machine seizing up.
•
Never attempt to split any trunks which are either
too long or too small and do not fit in the machine
properly.
•
Never attempt to split any trunks which contain
nails, wire or any other objects.
•
Clear up while you work; collections of split wood
and wood chips can make your work area danger
-
ous. Never continue working if your work area is
full to the extent that you could slip, trip or fall over.
•
Keep onlookers well away from the machine and never
permit unauthorized persons to operate the machine.
Содержание 5905503902
