Scheppach 5903805901, Перевод оригинального руководства пользователя

Страница: 29 / 104

www.scheppach.com
GB
| 29
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob -
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer’s customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per -
sonal data from the old device being disposed of!
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards)
- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
15. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly.
If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
Power tool does not
start
Power supply interrupted Check power supply by connecting another
power tool
Power cord or plug defective Have an electrician check the tool
Other electrical defect of the
electric tool
Have an electrician check the tool
Power tool does not
operate with full power
Extension cord too long and/or
cross-section too small
Use extension cord with permissible length
and/or adequate cross-section
Power supply (e.g. generator)
voltage is too low
Connect power tool to an appropriate power
supply
Poor operation results Accessory worn out Have accessory replaced
Sanding plate worn out Have sanding plate replaced
Considerable dust
formation
Brush edge worn out Have brush edge replaced
Dust extraction not connected/
switched on
Connect / switch on dust extraction