Scheppach 5801208901, Оригинальное руководство пользователя

Страница: 67 / 80


www.scheppach.com /

service@scheppach.com /

+(49)-08223-4002-99 /

+(49)-08223-4002-58
GB | 67
• Open the set screw (16b) for the moveable stop rail (16a) and push the
moveable stop rail (16a) inwards.
• The moveable stop rail (16a) must be locked in a position far enough
from the inner position that the distance between the stop rail (16a)
and the saw blade (6) is no more than 8 mm..
• Before making the cut, check that the stop rail (16a) and the saw blade
(6) cannot collide.
• Re-tighten the set screw (16b).
• Move the machine head (4) to its upper position.
• Use the handle (1) to push back the machine head (4) and fix it in this
position if required (dependent on the cutting width).
• Place the piece of wood to be cut at the stop rail (16) and on the turn-
table (14).
• Lock the material with the clamping devices (7) on the fixed saw table
(15) to prevent the material from moving during the cutting operation.
• Release the lock switch (3) and press the ON/OFF switch (2) to start
the motor.
• With the drag guide (21) fixed in place (21):
Use the handle (1) to move the machine head (4) steadily and with
light pressure downwards until the saw blade (6) has completely cut
through the work piece.
• With the drag guide (21) not fixed in place (21):
Pull the machine head (4) all the way to the front. Lower the handle (1)
to the very bottom by applying steady and light downward pressure.
Now push the machine head (4) slowly and steadily to the very back
until the saw blade (6) has completely cut through the work piece.
• When the cutting operation is completed, move the machine head
back to its upper (home) position and release the ON/OFF button (2).
Attention! The machine executes an upward stroke automatically due
to the return spring, i.e. do not release the handle (1) after completing
the cut; instead allow the machine head to move upwards slowly whilst
applying light counter pressure.