Schaudt DT 201 B, Инструкция по эксплуатации

Страница: 8 / 24

8
Situation: 18.07.2005 SDT-0018-02EN
Instruction Manual Control and Switch Panel DT 201 B
Defroster unit The defroster unit can be switched on and off or set to automatic operation in
the basic menu. Depending on the setting, "ON", "OFF" or "AUTO" is indicat-
ed in the display window. This menu is only displayed if the defroster unit is
installed.
In automatic operation, the defroster unit is automatically switched on if the
outside temperature falls below +7.5 °C and automatically switched off if the
temperature rises above +7.5 °C.
Setting the time
„
Press the "MENUE" button for more than 3 seconds.
The basic display is displayed.
„
Press the "MENUE" button several times until the "TIME" page of the basic
menu is displayed. The hour display flashes.
„
Set the hours with the "+" or "–" button.
„
Press "OK" button.
The hour entry is confirmed. The minute display flashes.
„
Set the minutes with the "+" or "–" button.
„
Press "OK" button.
The minute entry is confirmed. The time is set.
Setting the date
„
Press the "MENUE" button several times until the "DATE" page of the
basic menu is displayed. The year display flashes.
„
Set the year with the "+" or "–" button.
„
Press "OK" button.
The entry of the year is confirmed. The day display flashes.
„
Set the day with the "+" or "–" button.
„
Press "OK" button.
The entry of the day is confirmed. The month display flashes.
„
Set the month with the "+" or "–" button.
„
Press "OK" button.
The entry of the month is confirmed.
Software version and
parameter number
„
Press the "MENUE" button several times until the software version and the
four-digit parameter number are displayed. These settings cannot be
changed.
„
To exit the menu, press any button or wait for 20 seconds until the display
automatically switches to the basic display.
„
Press "OK" button.
W
Both defroster outputs are designed only for operation with the liquid gas
control units Truma Duomatic L plus or Truma Triomatic and may only be
used together with these units. The maximum load current for each output
is 0.4 A.
W Software version and parameter number are required for queries at the
dealer or customer service. Always have these settings ready for queries.
W For the correct functionality, the parameter number must be modified if
special equipment is installed at a later date. You can obtain further infor-
mation at your dealer or at Schaudt GmbH customer service.