Schaub Lorenz SLK GB6227L, Руководство пользователя, Страница: 18 / 60

Tightness Control of Part Connection

Ensure that all of the buttons are off on the product. Be sure that the
gas is on. For the control of the gas leak, rub a small amount of soap to
the hose connector.

If the gas leak would be foaming at the soap. Please review this case,
gas connection again.
W AR NI NG: N
ever use matches and lighters flame to check gas
leak.
GAS CONVER SI ON
Burners in your hob can be operated by different gases by installing
injectors suited for gases required to be fired. Contact with the
authorized service for your gas type changes.
Injectors change should be carried out by the authorized service staff as
follows;

Remove fire bars and burners by lifting them upward.

Remove injectors by turning counter-clockwise and reassemble
new injectors suited for gas types to be used.
( See Table 1)

Tighten injectors properly.
I MPOR TANT: T
ightening the injector too much causes to
become w orn and occur gas leakage, for this reason do not
force too much w hen you make sure of tightening the injector
adequately.

After installing the injectors, check the gas leakage by foam.
For this process, foam the bottom of injectors, push over the injector
with your finger so as to close the gas outlet and check whether
bubbles occur in the connection point of injector or not.
18