Scharfen ATM-3, Руководство по эксплуатации

Страница: 11 / 15

Page 11
Taking off the end piece holders
Pull the carriage to the front.
Loosen the fixing screws of the end piece holders.
Take off both end piece holders.
Tilting the carriage aside
Loosen the star knob of the carriage.
Pull the carriage to the utmost front position.
Tilt the carriage aside.
The carriage cannot be tilted aside in case
-
the thickness plate is still opened
-
the carriage has not been adjusted to manual movement.
-
Always tilt the carriage with care, do not use force!
Taking off the blade guard

Loosen the star knob and hold the blade guard with the other hand.

By pushing against the star knob the blade guard is tipped against your hand
and you can take the blade guard off
For cleaning only use usual washing-up liquids. Do not use
scratching or scouring cleansing agents or devices.
The machine is only drip-proof. Therefore do not use high
pressure cleaning devices, water hoses or similar devices.
Furthermore you must not pour water over the machine.
Danger of short circuit or machine defect. In such cases any
claims regarding warranty will be refused.
4.2. Cleaning the single parts
Clean all removed parts separately with warm water. Wash them up with clear water and dry them. See
also Chapter 6. Maintenance and Cleaning.
4.3. Cleaning the blade
Attention! Risk of getting hurt!
Make sure that the thickness plate is closed completely and the
machine is switched to manual movement (3.4)

When the thickness plate is closed completely clean the inside of the
blade with a wet cloth from the centre towards the edge.

Proceed for the backside of the blade in the same way.

Dry the inside and the backside of the blade carefully.
1. Put a moist cloth between the blade and the fixed protecting ring.
2. Turn the blade by hand one complete rotation and push the moist cloth against the protecting ring
while turning.