www.schalk.de
Motor controllers
M
ot
or
c
on
tr
ol
le
rs
Configuration and commissioning
1) Press and hold the OPEN and CLOSE inputs at the same time for 10 seconds
This activates programming mode with the programming process.
Restoring factory default settings:
If the controller is accidentally misconfigured, this can be corrected by restoring the factory default settings.
To do this, press the
OPEN
and
CLOSE
buttons at the same time
for 20 seconds
until the LED blinks green and red (on the
SMS 2, all LEDs will blink).
Factory default settings
After 30 seconds in setting mode with no button press, setting mode is exited automatically and all set-
tings made up to that point are accepted.
Ì
Terminal 14 retracts or raises the awning (OPEN button)
Ì
Terminal 24 extends or lowers the awning (CLOSE button)
Info
Step 1: Adjust the response time for shading (and for twilight with SMS 2)
(SMS U2: LED lit green / SMS 2: LEDs B and D lit red)
The factory default response time is 10 minutes. This can be increased incrementally by pressing the OPEN button or de-
creased incrementally by pressing the CLOSE button. To skip this setting, go directly to Step 2.
One button press corresponds to 1 minute response time
(Setting range: 1–60 min)
2)
Briefly
press the OPEN and CLOSE buttons at the same time
This takes you to the second programming step and saves any previous settings you have made.
Step 2: Adjust the motor run time
(SMS U2: LED lit red / SMS 2: LED W lit red)
The factory default motor run time is 90 seconds. If the awning should only be extended to a specific position in automatic
mode, all you have to do here is to extend it to this position by pressing the OPEN or CLOSE buttons. To skip this setting, go
directly to Step 3.
(Setting range: 1–240 s)
3)
Briefly
press the OPEN and CLOSE buttons at the same time
This takes you to the third programming step and saves any previous settings you have made.
Attention!
Note: The awning must be in the home position (fully retracted) for this.
The following default values are configured in the factory:
- Response time for sun exposure: 10min
- Motor run time: 90s
- Group mode disabled
First configure the threshold values and sensor type using the corresponding controls (see “Controls and indicators”). The
following settings only have to be configured if the factory default settings are not suitable (see “Factory default settings”).
Step 3: Enable or disable group mode
(SMS U2: LED lit red-green / SMS 2: LEDs B, D and W lit red)
Group mode is disabled by default (factory setting). Press the OPEN button to enable group mode, or press the CLOSE
button to disable group mode.
4)
Briefly
press the OPEN and CLOSE buttons at the same time
This exits programming mode and saves any previous settings you have made.
