
All radio transmitters of the device series Fx3 (= FS3, FD3) and FV2 are compatible with the radio repeater FV2 R
Compatibility
Transmitter
Repeater
Receiver
FS3-/
FV2-
series
FD3-/
FE3-/
FV2-
series
Electrical connection and range optimization
Notes on wireless range:
The antenna of the devices is located just above the bottom
of the housing and runs along the right and top edges of the
housing. This area must have sufficient distance to metal
surfaces. Since the radiation is not homogeneous, the range
can be significantly improved by aligning the devices (to be
determined in the experiment). The installation site should
be at least 1 m above ground level.
For a good radio range and reliable radio reception, please
observe in general:
- Do not mount radio modules directly on metal surfaces.
- Avoid metallic housings and shields
- Align transmitter and receiver optimally to each other
- Install at highest possible locations (>1m above ground)
- Please note: damp or steel-reinforced walls and ceilings,
moist soil, etc. attenuate any wireless radiation
Other electronic consumers (ballasts, switching power sup-
plies, power regulators, etc.) may cause locally limited radio
interference in individual cases.
In the event of a fault, please try to establish sufficient dis-
tance to an affected radio module.
www.schalk.de
Radio connection system Wireless Wire
®
Ra
di
o
con
ne
ct
ion
sy
st
em