Teaching radio protocols
Teaching in with a transmitter from the FS3 series:
1) By briefly pressing the "Prog." key on the FV2 R, the pro-
gramming mode is activated. LED Rx lights up green.
2) On the transmitter, press the send button to be pro-
grammed briefly.
The Rx LED on the repeater goes out when a valid signal is
received. The teach-in process is thus successfully com-
pleted.
If the repeater cannot receive a valid radio protocol within
20s, the teach-in process is automatically aborted.
In this way, up to 12 response codes can be learned.
Teach-in process with magnetic contact transmitter FV2
SM:
1) By briefly pressing the "Prog." key on the FV2 R, the pro-
gramming mode is activated. LED Rx lights up green.
2) Briefly press the programming button in the open trans-
mitter. The LED in the transmitter starts to light red.
3) Now press the programming button in the transmitter
again and keep it pressed until the red LED goes out.
The Rx LED on the repeater goes out when a valid signal is
received. The teach-in process is thus successfully com-
pleted.
If the repeater cannot receive a valid radio protocol within
20s, the teach-in process is automatically aborted.
Teach-in process with transmitter FV2 S:
1) By briefly pressing the "Prog." key on the FV2 R, the pro-
gramming mode is activated. LED Rx lights up green.
2) At the transmitter by repeatedly briefly pressing the “Prog."
button, select the radio channel to be tuned in (B1 to B4) The
corresponding LED lights red.
3) Now press the"Prog." button on the transmitter again and
keep it pressed until the red LED goes out.
The Rx LED on the repeater goes out when a valid signal is
received. The teach-in process is thus successfully com-
pleted.
If the repeater cannot receive a valid radio protocol within
20s, the teach-in process is automatically aborted.
A maximum of 12 different radio protocols can be tuned in.
The Rx-LED and Tx-LED flash twice simultaneously if an at-
tempt is made to learn more than 12 radio protocols.
Deleting radio protocols
Delete the last taught-in radio protocol:
1) By briefly pressing the "Prog." key on the FV2 R, the pro-
gramming mode is activated. LED Rx lights up green.
2) Now press the"Prog." button on the transmitter for more
than 5s. The Rx and Tx LEDs flash 3 times to confirm.
Delete all taught-in radio protocols (restore factory set-
tings):
If the repeater is not in teach-in mode and the "Prog.” button
is pressed for longer than 10s, all taught-in radio protocols
are deleted. The repeater is thus reset to its factory setting.
The Rx and Tx LEDs flash 5 times to confirm.
LED function display
Tx-LED flickers red:
Valid radio protocols are received and transmitted (normal
repeater operation).
Rx-LED flickers green:
Unlearned radio protocols are received correctly, but not
forwarded.
Radio connection system Wireless Wire
®
www.schalk.de
Ra
dio
con
ne
cti
on
sy
ste
m