3
1
2
1
Power +24 V
Hirose series 10A, male 4-pin
Total power: 4.3 W
Pin
Signal
Pin
Signal
1
n.c.
3
min. +18 V
max. +36 V
2
GND
4
n.c.
2
1
3
4
Power Cable SK9014.xF
Use this cable to feed external supply voltage into socket
1
.
Connector:
Hirose plug HR10A, female 4 pin (camera side),
open cable end (other side)
Length 1.5 m (standard), 3 m, or 5 m
Line Scan Camera SK2048GJR-4L Manual (09.2016) • shar
ed_Installation-ElectrV_ML.indd (09.2016)
8
SK2048GJR-4L
Instruction Manual
(09.2016)
© 2016
Schäfter + Kirchhoff GmbH
•
Hamburg
Installation and Setup
2.2
Electrical Installation: Connections and I/O Signals
External Synchronization Cable SK9024.x
Use this cable to feed external synchronization
signals into socket
2
.
Connectors:
Hirose plug HR10A, female 12 pin (camera side)
Phoenix 6 pin connector incl. terminal block (for
synchronization signals)
Length 3 m or 5 m. Other lengths on request.
Network Cable CAT6.x
For connecting socket
3
with the PC Ethernet
interface. Both ends with RJ45 connectors.
• For the SK2048GJR-4L line scan camera-data transfer and camera control is provded by the Gigabit Ethernet
interface
3
. Use a CAT6 twisted-pair cable to connect the camera to a PC; the maximum cable length is
100 m.
• The operating power must be supplied by an external source using socket
1
• If you want to operate the camera in FREE RUN trigger mode, the connections are complete with the CAT6
Ethernet cable and the connection to an external power supply.
• For any kind of synchronized operation, the external trigger signal(s) must be wired to socket
2
as well. A
frame-synchronization signal and two separate line-synchronization signals can be handled. The various
trigger modes are described fully in section
Synchronization of the Imaging Procedure and the Object Scan
2
1
3
4
5
6
7
8
9
10
11
12
2
1
3
4
5
6
Pin
Signal *)
1
GND
8
FrameSync IN
10
LineSync A IN
6
LineSync B IN
2
I/O Connector
Hirose series 10A, male 12-pin
*) Signal Specification
(TTL)
Max. input frequency
16.5 MHz
Input voltage,
absolute max. range
min -0.5 V
max 7.0 V
Input voltage max. low
0.99 V
Input voltage min. high
2.31 V
Input current
10 µA
3
Data
RJ45 con nector for Gigabit Ethernet cable
Status indicators
Network connection speed
Network activity
off
no connection,
10 Mbyte/s connection, or
100 Mbyte/s connection
on
1 Gbyte/s connection
off
no connection
on
connected
flash
light
data is being
transmitted or
received
Accessories
:
