5
INSTALLATION REQUIREMENTS
Support Structure:
The fan mount bracket must be installed on a support structure strong enough for the
added weight of the bracket and fan. Suitable material choices are wood, cement,
brick and steel. Wood supports must be 3" x 3" square post or larger.
Mounting Hardware:
THE HARDWARE TO ATTACH THE FAN MOUNT BRACKET TO THE STRUCTURE
IS NOT SUPPLIED. HARDWARE MUST BE ADEQUATE TO SAFELY SUPPORT THE
LOADS SHOWN IN THE TABLES BELOW.
Attach the fan mount bracket with (3) washers and (3) screws or bolts with Nylock nuts
suitable for your installation (2 fasteners at the 90° bend; 1 fastener at the end away
from the swivel tab). Fasteners should be 5/16"diameter, Grade 2 or better. Lag
screws used for wood installation must be at least 2" long. Always follow the fastener
manufacturer's installation instructions.
Attach the Fan:
THE HARDWARE TO ATTACH YOUR FAN TO THE FAN MOUNT BRACKET IS NOT SUPPLIED IN THIS KIT.
Note:
Fasteners are supplied with all current Schaefer circulation fans.
Note:
Stainless steel fasteners should be coated with a lubricant (WD-40) to prevent thread galling and
allow subsequent adjustment.
Install (1) 3/8" x 1-1/4" bolt, (2) washers and (1) Nylock nut through Swivel Tab hole
Install (1) 1/4" x 1" bolt, (2) washers and (1) Nylock nut through Swivel Tab slot
Once fan is securely attached to the Swivel Tab, orient
the fan horizontally and tighten the Swivel Tab hardware
to prevent the fan from turning.
Adjust the fan to desired angle and
securely tighten the hardware.
CAUTION: Fasteners will loosen over time. It is important to check and tighten fasteners frequently.
CAUTION: Inspect mounts and fasteners frequently for corrosion. Replace any corroded fasteners or parts.
Disconnect power before cleaning or maintaining your fan in order to prevent serious injury or death.
!
• Excessive dust and debris may cause overheating and reduced fan performance.
• Keep guards, motor and blades clean by vacuuming or wiping with a damp cloth.
• Do not use harsh chemicals or cleaners to clean any part of the fan.
• Pressure washing the unit will void the warranty.
• Sealed motor bearings are pre-lubricated and do not require servicing.
CLEANING AND MAINTENANCE
