3
INSTALLING THE FAN TO A PEDESTAL ASSEMBLY
Use the supplied hardware that came with your fan to attach the fan.
1. Position the fan assembly with the Oscillator Base at either side of the
mounting tab.
2. Install the 3/8" bolt through the center hole of the Oscillator Base and
fasten with 3/8" narrow washers and nylock nut.
3. Install the 1/4" bolt through the slot feature and fasten with 1/4" narrow
washers and nylock nut. Adjust the fan to the desired angle* and securely
tighten all mounting hardware.
(* 36" models must be mounted so the fan blade is perpendicular to the
floor)
INSTALLING THE FAN ON A WALL MOUNT BRACKET
Note:
Wall Mount Bracket must be orientated as shown (with mounting
leg and diagonal brace down).
Use the supplied hardware that came with your fan to attach the fan.
1. Fasten the Oscillator Motor Mounting Yoke to the Wall Mount Bracket
using the 3/8" carriage bolt, 7/16" wide washer and nylock nut as shown.
2. Install the 3/8" bolt through the center hole of the Oscillator Base and
fasten with 3/8" narrow washers and nylock nut.
3. Install the 1/4" bolt through the slot feature and fasten with 1/4" narrow
washers and nylock nut. Adjust the fan to the desired angle* and securely
tighten all mounting hardware.
(* 36" models must be mounted so the fan blade is perpendicular to the
floor.)
CAUTION: Fasteners may loosen over time. It is important to check
and tighten fasteners frequently.
CAUTION: Inspect mounts and fasteners frequently for corrosion.
Replace any corroded fasteners or parts.
Safety Cable: (Safety Cable Kit sold separately.)
A SECONDARY SUPPORT CABLE SHOULD BE INSTALLED ANYTIME THE FAN IS MOUNTED
OVERHEAD FOR ADDITIONAL SAFETY.
Safety Cable must go around the Large Diameter Wires of the Front and Rear Guards. The
other end of Safety Cable must be securely fastened to a building joist, truss, or beam near
the fan. Take up all unnecessary slack in the cable.
