5
Safety
SPECIFICATIONS
This applicance is an infrared portable heater. The burner is controlled and adjusted by the control
knob. The gas supply is controlled by the valve on the gas cylinder. The burner is made of
stainless steel. Heat diffusion is assisted by the reflector above. Objects placed under a heater
while it is operating are subject to radiant heat and may be damaged. This heater is approved for
outdoor use only.
•
Operating pressure
11" WC
•
Maximum output
45,000 BTUH
•
Minimum output
25,000 BTUH
•
Gas consumption at HI
1 kg/h
•
Burner orifice
1.9mm
FOR YOUR SAFETY
IF YOU SMELL GAS:
1.
Close the valve on the gas cylinder.
2.
Extinguish all open flame in the area.
3.
Perform a leak test (see previous page)
4.
If bubbles are detected, tighten the connection(s). If no leaks are detected, open the
valve on the gas cylinder and verify you still smell gas.
5.
If you still smell gas, turn the heater control knob to OFF and close the valve on the
gas cylinder. Contact your dealer or a qualified gas technician.
Never store or handle gas, or any other flammable vapors or liquids in the vicinity of the heater or any gas appliance.
Faulty installation, modifications, repairs or maintenance to the heater may be the cause of injury or damage to property.
CAUTIONS
•
DO NOT operate the heater in an explosive environment. Keep away from areas where gas,
other vapors or flammable liquids are stored.
•
BEFORE EACH USE verify that no parts are damaged and inpect the gas hose.
•
Never modify this heater in any way.
•
Never use the heater without the reflector.
•
Observe minimum clearances as shown (24" from edge of reflector; 18" above reflector).
•
Always place the heater on a level, stable, hard surface.
•
Provide fresh air ventilation at all times. Do not obstruct the ventilation opening (hand hole)
on the cylinder cover.
•
Never clean with abrasive, corrosive or flammable cleaners.
•
Do not paint the heater or any of its parts.
•
Perform a leak test when heater is first assembled, and each time the hose has been
disconnected, before lighting.
•
Never leak test with an open flame nearby or while smoking.
•
The valve on the gas cylinder must be fully closed when not using the heater.
•
Anyone in the vicinity of the heater should be made aware of hot surfaces.
•
Do not hang clothing or other objects on the heater to dry.
•
Installation, maintenance and repair of the heater should always be done by a qualified gas technician.
•
In case of high winds, turn the heater control knob to OFF and close the valve on the gas cylinder.
Remove the reflector.
•
Do not move the heater while it is operating or still hot.
Clearances
Dimensions