Assembly Instructions
3
STEP 2
Fasten the post to the vertical supports
using six M6x35 bolts and six M6 nuts.
STEP 4
Slide the regulator hose through the
post and connect to the burner head.
* IMPORTANT NOTE *
A thin layer of teflon tape should be
applied to the threads on the gas valve
before attaching the hose to ensure a
safe, tight connection.
STEP 5
Fasten the burner head on the post with
four Phillips head M6x10 screws.
STEP 6
Insert a bolt from the inside
through each of the three tabs on
top of the emitter. Place a steel
washer on each bolt. Lay the
reflector over the washers and add
another washer on top before
tightening a wing nut on each bolt.
STEP 3
Slide the cylinder cover over the
post.
STEP 1
Attach three vertical supports to
the base using three M8x15 bolts.
STEP 7
Place a 20 lb propane cylinder on
the base. Connect the gas regulator
hose to the cylinder valve by
turning the knob clockwise.
DO NOT USE A TOOL; TIGHTEN
BY HAND ONLY.
Replace cylinder cover.
* IMPORTANT NOTE *
A leak test should be performed
before lighting the heater to ensure
safe operation (see next page).