– 2 –
– 3 –
FIGURE 1: HEIGHT EXTENDER BLOCKS
1.
Unfold the loom on a flat surface.
Tighten the fold knobs and engage the slide
locks so the loom is fully extended and
locked.
2.
Match each height extender with the
appropriate leg (Figure 1).
3.
Remove the arrow peg that is pushed
through the brake cord underneath the
brake release pedal. Using a pair of 9/16"
wrenches, remove the 3/8" x 3" hex bolt
holding the brake release assembly to the
right outside leg. Save all of these parts
except for the hex bolt; you will need them
in Step 8.
4.
Remove the 1/4-20 x 3" Phillips truss
head machine screws and the 1/4-20 barrel
nuts holding the rear leg brace from the
hole closest to the floor [A] on each outside
leg (Figure 2). Remove the rear leg brace;
set it aside with the hardware for Step 5.
5.
Attach the LO and RO height extender
blocks to the rear leg brace by inserting
the tenon of the brace into the mortise
of the height extender blocks (Figure 3).
Secure the height extender blocks with
the hardware from Step 4: insert a 1/4-20
x 3" Phillips truss head machine screw
through the bottom hole of the height
extender block and thread it into a barrel
nut inserted into the rear leg brace. Hold
the barrel nut in position with a slotted
FIGURE 2: OUTSIDE LEG
rear leg
brace
barrel nut
B
A
right outside leg
tenon
mortise
FIGURE 3: REAR LEG BRACE AND HEIGHT
EXTENDER BLOCK
inside leg height extender blocks
outside leg height extender blocks
outer side inner side
LI
RI
outer side inner side
inner side
inner side outer side
outer side
TOP
BOTTOM
LO
RO
LO = left outside
RO = right outside
RI = right inside
LI = left inside
