– 2 –
– 3 –
WOLF PUP 8.10 STROLLER
a
SSembly
i
nStructionS
PARTS LIST
4 – caster blocks with casters
2 – stroller support bars
2 – ¼" x 3" trusshead machine screw
2 – ¼” x 3 1/2" trusshead machine screw
4 – ¼" x 2 ¼" carriage bolts
2 – ¼" x 1 1/2" hex bolts
2 – ¼" x 1 ¾" hex bolts
1 –
3
/
8
" x 3 1/2" hex bolt
8 – ¼" washers
1 –
3
/
8
" washer
8 – ¼" lock nuts
2 – ¼" wing nuts
TOOLS
Phillips screwdriver
Flat screwdriver
drill w/ 1/4" bit
Rubber mallet or hammer
Piece of scrap wood
NOTE: Wolf loom legs are called out by where they cross each other. The legs
that touch the ground at the front of the loom are called “inside” legs because
they are covered by the “outside” legs when they cross at the loom center.
screw though the caster block and height
extender (if attached) into the treadle bar
(Figure 2). Using a flat screwdriver to hold
the barrel nut in place, tighten the bolt
into the barrel nut. Repeat for the other
front caster block.
4.
Attach the caster blocks to the outside
legs and the rear leg brace.
Remove the
trusshead bolts (D) holding the rear leg
brace to both outside legs (Figure 1).
5.
Attach the right rear caster block
with the new 4" machine screw through
the bottom hole (C) and the caster wheel
towards the back and on the floor (Figure
3). Tighten the bolt into the barrel nut so
that the stroller rotates, but is not loose.
1.
Install the wolf stroller on a hard
surface.
Open the loom to weaving
position (see front cover illustration).
2.
Attach the stroller caster blocks to the
inside legs and the treadle bar.
Locate
the trusshead bolt (B) that attaches the
inside leg height extender to the treadle
bar (Figure 1). Remove the bolt from the
leg. The barrel nut that held the bolt slips
out of the underside of the treadle bar.
Discard the bolt and keep the barrel nut.
3.
Set a caster block on the outside of
the leg, with the caster wheel toward the
front and on the floor. Line up the hole
(C) at the bottom of the block to the hole
(B) in the leg and insert a new 4” machine
FIGURE 1
treadle bar
rear leg
brace
barrel nut
barrel nut
B
H
H
D
inside
leg on
right side of loom
outside
leg on
right side of loom
