– 2 –
– 3 –
■
Insert the shaft of the quick release le-
ver into the left side of the wheel, through
the bulky front maiden and on through
the right wheel side. Place the washer and
knob onto the quick release lever shaft,
compressing the spring on the lever side
until there is about an 1/8" or so of space
between the lever and the wheel side.
Close the quick release lever. The knob
should be just tight enough to need firm
pressure to close the lever.
If the lever closes loosely, open the lever,
tighten the knob a bit, and try closing the
lever again. If the lever requires a lot of
pressure to close, loosen the knob a bit.
INSTALL THE BULKY FLYER
■
Loosen the front maiden so that it can
be tipped toward you as you sit in front of
the wheel.
■
Put the bobbin on the flyer with the
large end toward the back. Put your de-
sired whorl on the flyer.
■
Place the Scotch tension string on the
bobbin and the drive band into the whorl
groove.
■
Insert the end of the flyer shaft into the
rear maiden bearing.
■
Insert the orifice into the front maiden.
■
Push the front maiden against the
stops, make sure it is vertical, and secure
with the quick release lever.
■
Check to make sure the rear maiden is
vertical and pushed against its stops.
REMOVE THE
STANDARD FRONT MAIDEN
■
Remove the flyer, bobbin and whorl.
■
Open the front quick release lever and
unscrew the quick release knob. Remove
the knob and washer, then pull out the
quick release lever shaft.
■
Remove the front maiden and store.
INSTALL THE
BULKY FRONT MAIDEN
■
Place the bulky front maiden between
the wheel sides with the logo facing the
front of the wheel.
CONTENTS
■
Bulky front maiden & bearing
■
Bulky flyer
■
Bulky bobbin
front
maiden
BULKY BOBBIN, FLYER, AND FRONT MAIDEN
adjustable
flyer hook
stationary
flyer hook
orifice
bearing
flyer shaft
shoulder
quick
release
lever
quick
release
knob