Introduction
Page 17
Internal radio sounders
SND-RINT internal radio sounders are intended for use in areas that are out of audio
range of keypads, but where users need to hear system sounds.
Internal radio sounders can communicate directly to control units that have built-in radio
communications, or to radio expanders. Table 1 specifies the number of internal radio
sounders that each type of control unit can support.
Loudspeakers
Control units (except i-on Compact), expanders and remote power supplies have
connections for a loudspeaker, which you may want to use to increase the volume or
location of setting and unsetting tones. The loudspeaker must have an impedance of 16
Ohms. You must not connect two loudspeakers in parallel to the same port.
Cameras
You can configure the system to store images from a network camera when an alarm
occurs. The following network cameras are supported:
CAM-INT-00
Internal box camera wired/Wi-Fi.
CAM-EXT-00
External bullet camera wired/Wi-Fi.
A micro-SD card is required to store the camera images.
Remote power supplies
The EXP-PSU remote power supply is supported, which provides:
Extra power and more space for standby batteries in larger alarm systems.
Connections for either 10 FSL zones, five 4-wire CC zones, or 10 2-wire CC zones.
A loudspeaker output.
Four wired programmable outputs.
16 plug-by outputs.
The EXP-PSU connects to the system bus (see page 26), and communicates with the
control unit in the same way as a wired expander.
Remote controls
A remote control allows the system to be set or unset using a keyfob (similar to a device
for locking/unlocking a vehicle).
The following devices are supported:
i-FB01
Remote control.
FOB-2W
2-Way remote control.
WiFi module
An i-wifi01 module allows any i-on control unit to connect wirelessly to the network. The
module is mounted inside the control unit and connects to the Ethernet port.