Introduction
Page 13
KEY-EP external proximity tag reader
A KEY-EP external proximity tag reader can connect to a KEY-KP01, KEY-KPZ01 or
KEY-FKPZ keypad to enable the system to be to set or unset externally.
Many keypads also include an internal proximity tag reader.
Detectors (zones)
Detectors are the physical devices that detect alarm conditions. A zone is the lowest-level
item within the intrusion system that can be set or unset.
Note:
Although it is possible to connect detectors in series and therefore to have more
than one detector in the same zone, it is not normal practice. Instead, there is normally
only one detector per zone and for this reason, detectors are often referred to as "zones"
within the intrusion system.
Table 1 shows the number of zones supported by each control unit.
Wired detectors
Wired detectors can connect (using standard alarm cable) to some models of control unit
(see Table 1), wired expanders, keypads and remote power supplies, as described in the
previous sections.
Please refer to page 22 for details of the different wiring methods you can use for wired
detectors.
Note:
If 4-wire CC wiring is used, this may reduce the available number of zones; see
All wired detectors with contacts that open and close are supported, as there is no protocol
involved.
Radio detectors
Radio detectors can communicate directly to control units that have built-in radio
communications, or to radio expanders. Table 1 specifies the number of radio zones that
each control unit supports.
The following radio detectors are supported:
DET-RDC
Slimline door contact
DET-REXT-PIR30
External perimeter PIR
DET-REXT-IR50/100 Barrier detectors
DET-RS
Shock or movement detector
XCELR
PIR
XCELRPT
Pet-tolerant PIR
DET-RDT
Combined microwave and PIR detector
720rEUR-00
Smoke detector
DET-RSMOKE
Smoke Detector
705REUR-00
Hand-held dual-channel transmitter
706rEUR-00
10mW tilt switch and personal attack transmitter.
710rEUR-00
Dual-button personal attack transmitter