Scantronic HOMELINK EXTRA, Руководство по программированию

Страница: 5 / 40

496759 Page 5
1. Introduction
The Homelink Extra and Homelink Extra II can be programmed using a
PSION Organiser II programmer. If you have not used a PSION programmer
before then read “Using the PSION Programmer”. If you are already familiar
with using the programmer on other types of Homelink then skip to the
section “The HLEXTRA Program”.
For simple programming (telephone numbers, account codes, and site
codes) you can use a DTMF phone connected to a socket under the access
panel, see “Installation and Programming” for the Homelink Extra (496758) .
If you wish to program the extra facilities that Homelink is capable of then
you should read the rest of this Introduction first.
Using Homelink as an Intruder Alarm
The user can make Homelink work as a simple intruder alarm by pressing
the green AWAY button. The user’s home must be fitted with the appropriate
sensors, for example door contacts or movement detectors. After the user
has pressed AWAY, Homelink will report any activation of these sensors as
an intruder alarm.
The sequence of events is as follows:
1.
The user presses AWAY.
2. Homelink flashes the Away lamp and gives a continuous tone for a set
entry/exit time.
3. At the end of the entry/exit time the Away lamp glows steadily and
Homelink is set.
4. If any of the sensors signal an intrusion, Homelink waits the entry/exit
time and then calls the telephone number you have assigned. When
Homelink has established the alarm call it opens the speech link so that
the monitoring station can listen and check that it is not a false alarm.
Once Homelink has set up the alarm call then an intruder cannot cancel it by
pressing AWAY. If someone presses the Emergency button after Homelink
is set then Homelink will send an Emergency alarm call and go back into its
normal mode. The user can unset Homelink by pressing AWAY during the
entry/exit time.
To set up this facility correctly use the following options:
1.
Switch Home & Away to "on" in the Reporting Map to assign the
telephone number Homelink must call when the user presses AWAY.
2. Use the Entry/Exit option to change the Entry/Exit Time.
3. Use the Intruder Alarm Option to give the user an audible warning that
the intruder alarm has been activated.