Scantool Blackbolt 220 GSHT, Руководство пользователя

Страница: 34 / 52

34
8.9 Variable cutting angle selection
Please proceed as follows to obtain desired
cutting angle. The swivel range is from 0’ to 60*
clockwise. Before swinging the base, make sure
there is nothing in the way, or any interference.
4. Pull out the bar ( A ) (fig. 6 ) swing and hold
the bar.
5. Push to turn the swivel base to desired
angle. Refer to scale on ( B ) for degree.
6. Lock the bar ( A ), then start the cutting.
8.10 Removing and installing the blade
When it is necessary to replace the blade, proceed as follows:
8. Raise the saw frame about 6” and close the on/off knob by turning it clockwise as
far as it will go ( fig 8 ).
9. Move the blade guide arm to
the right. ( Fig 9 ).
10. Disconnect the machine from
the power source. Loosen
cover screw, remove cover ( A
), open the cover ( B ),
remove cover ( C ), then clean
the chips and dirt inside the
machine.
11. Release blade tension ( F )
(fig 9 ) by turning the blade tension hand-wheel counterclockwise.
12. Remove the blade from both wheels and out of each blade guide. But remove side
( B ) saw blade. When totally released, then remove the side ( A )
13. Make sure the teeth of the new blade are pointing in the right direction. If
necessary, turn the blade inside out.
14. Place the new blade on the wheels. In the blade on the wheels. In the blade guides
and adjust blade tension and blade guides.