FM radio
1. To select FM, press the
DAB/FM
button, the display will show FM and the frequency.
2.
To activate auto search, press and hold the
▲
or
▼
button until it starts to scan the frequency band,
the display will show “Searching … > .” or “Searching … < .”, and it will stop automatically once a
station has been found. (F. 6) (F. 7)
3.
To activate manual search, repeatedly press the
▲
or
▼
button.
4.
To select audio mode, press the
SELECT
button to toggle between the “Auto” or “Mono” selection.
Note:
The radio will automatically switch between stereo and mono mode, but you can override this and
switch this function manually which is helpful for poor signal reception.
STORING AND RECALLING STORED STATIONS
You can store up to 8 of your favourite stations (4 DAB and 4 FM) to the presets; this will enable you to get
direct access to your favourite station at a touch of a single button.
1. To store a preset, first tune to your desired station, then press and hold your preferred
PRESET
button
(
1 - 4
) until the display shows “Preset # saved”. (F. 8)
2.
To recall a preset station, press the
PRESET
button (
1 - 4
) that you have stored.
3.
If you press a preset that hasn't been allocated a station, the display will show “Preset # empty”. (F. 9)
FACTORY RESET
When you move the radio to another part of the country, your pre-tuned and stored DAB stations may no
longer be available. If this is the case then you will need to reset your radio back to its original factory
settings; to perform a factory reset, please do the following:
1. Plug the radio to mains and press the
STANDBY
button to turn the radio on.
2. Press and hold the
MENU
button until the display shows “Press SELECT to confirm reset”.
3. Release the
MENU
button and press the
SELECT
button once, the display will first show “Restarting
…” and after the reset is completed, the radio will go to standby.
4. Press the
STANDBY
button to turn the radio on again, it will then automatically enter into the DAB
mode and perform auto scan function. After the scan has finished, the radio will select and display the
first alphanumerically found station.
Note:
All of your stored DAB & FM presets will be lost once the reset has taken place.
ALARM FUNCTION
This radio can be used as a standard “Radio Alarm Clock” in AC operation. You can use the alarm function
to wake you to an electronic buzzer tone or to your favourite radio (DAB/FM). The alarm can be set in either
standby or during operation.
Setting the alarm time and wake-up mode
1. Depress and hold the
ALARM/SNOOZE
button until the display shows “Alarm Setting”. (F. 10)
2.
Repeatedly press the
▲
or
▼
buttons followed by pressing the
SELECT
button to adjust your desired
alarm time - first set the hour and then the minute.
3.
Finally press the
SELECT
button to confirm and the alarm time is set and you will enter into the wake-
up mode settings.
4. Repeatedly press the
▲
or
▼
buttons followed by pressing the
SELECT
button to adjust the wake-up
mode settings - first set the DAB Preset (1-10) and the FM Preset (1-10), then the Buzzer Tone (1 or
2), finally the Alarm Volume Level (1-20). (F.11)
5.
After the selection of the alarm volume level, the wake-up mode settings are completed and the alarm
function is ready for you to activate.
UK-4
F6
F7
F8
F9
F11
F10
