- 2 -
Need It. Rent It!
2. Make sure that the main power and hoses for the dust collector are connected to the machine.
3. Turn on the dust collector if used.
4. Push the handle downwards to lift the grinding head from the ground.
5. Press the start button (2) on the control device.
6. Lower the grinding head down to the floor.
7. Never let go of the handle during operation.
Stop
How to stop the machine
1. Press the stop button (1)
2. Wait until the machine comes to a complete stop before letting go of the handle
3. If a dust collector is used, turn off
Safety off position
When working on the machine, either maintenance or tool change, the machine must be set to the
“Safety off position”. The machine is in a safe condition where it cannot be any hazard.
How to set the machine in the Safety off position:
1. Switch off the machine
2. If a dust collector is used, switch it off
3. Wait for all drives to come to a complete stop
4. Disconnect the main power
5. Secure against unintended restart
Always disconnect the main power at the machine end to be able to prevent other persons from
accidentally reconnect the main power while working on the machine.
Grinding
Refer to “Grinding guide” for instructions and information about grinding.
Changing tools
How to fit the diamond segments on the Scan-On plate
1. Insert the segment at the widest part of the slot
2. Push the segment outwards
3. The segment is now fit on the Scan-On plate
To make sure that the segment is secured, use a small plastic hammer and slightly hit the segment
outwards. In reverse this technique can be used to loosen segments that are stuck.
