10
ZOC33
Section 3: Installation & Operation
SECTION 3: INSTALLATION & OPERATION
Unpacking
All ZOC33 modules have been extensively tested prior to
shipment. All modules are packed to minimize the chances
of shipping damage. However, damage can still occur. The
customer must inspect the modules and shipping materials
for obvious signs of damage. If it is suspected that damage
may have occurred, contact Scanivalve Corporation imme
-
diately.
Once you have unpacked the module, do an inventory
check of the shipment. Each shipment should at least
include a mating connector and this manual.
Overview
ZOC33 modules are designed to function best when
used with one of Scanivalve Corporation’s data acquisi
-
tion systems, either a DSM3000/3200/3400/4000 or
RAD3200/4000. All ZOC33 modules will function with older
data acquisition systems such as HyScan 2000/1000 as well.
They can also be used as a standalone module with another
high speed data acquisition system.
Electrical Inputs & Outputs
The Electrical Input and Output wiring is compatible with
all other ZOC cable serviced modules. The ZOC33 may
be installed into any existing Scanivalve systems without
changing configurations. If the ZOC33 is to be used in a
custom data system, refer to Figure 3.2.
The user is cautioned to follow safe instrument handling
practices when handling the ZOC33 modules. This includes:
(1) Make and break all connections to the
module with the power off.
(2) Recommended power input to the module is
±15Vdc.
Figure 3.2 shows the output connector pin assignments
for all of the ZOC33 variations. This figure shows the RTD
connections (+Tem and -Temp) and the TEDS ID chip output
(ID). These connections may not be active on all modules.
Refer to Section 2,
Introduction
for more information.
Figure 3.1 - ZOC33/64Px Exploded View
CAUTION! Not following standard
safe instrumentation handling
practices could permanently
damage the modules.
Содержание ZOC 33/64Px
