Troubleshooting
Caution! Before troubleshooting, disconnect
the power supply. Only a qualified electrician
or competent person must do the trouble-
shooting that is not in this manual.
Important! There are some sounds during
normal use (compressor, refrigerant circula-
tion).
If the malfunction shows again, contact the
Service Center.
These data are necessary to help you quickly
and correctly. Write the necessary data here,
refer to the rating plate.
Problem
Possible cause
Solution
Appliance does not
work
Temperature regulation knob is set at
number "O".
Set the knob at other number to switch on
the appliance.
Mains plug is not plugged in or is loose
Insert mains plug.
Fuse has blown or is defective
Check fuse, replace if necessary.
Socket is defective
Mains malfunctions are to be corrected by
an electrician.
The food is too
warm.
Temperature is not properly adjusted.
Please look in the initial Temperature Set-
ting section.
Door was open for an extended period.
Open the door only as long as necessary.
A large quantity of warm food was placed
in the appliance within the last 24 hours.
Turn the temperature regulation to a
colder setting temporarily.
The appliance is near a heat source.
Please look in the installation location sec-
tion.
Appliance cools too
much
Temperature is set too cold.
Turn the temperature regulation knob to a
warmer setting temporarily.
Unusual noises
Appliance is not level.
Re-adjust the feet.
The appliance is touching the wall or other
objects.
Move the appliance slightly.
A component, e.g., a pipe, on the rear of
the appliance is touching another part of
the appliance or the wall.
If necessary, carefully bend the compo-
nent out of the way.
Water on the floor
Water drain hole is blocked.
See the Cleaning and Care section.
Side panel is hot.
Condenser is inside the panel.
Its normal.
