- Remove the damper in the existing fireplace/chimney.
Clean the fireplace thoroughly of any soot residues.
-
Fasten the connection piece on a flexible tube in a suit-
able length (A) (if you use a smoke pipe instead of a
flexible tube, a special connection piece is available).
-
Fasten the flexible tube/smoke pipe in the chimney and
seal around it.
- Place the loose convection mantle of the insert on
the bottom of the fireplace (in the centre). The bottom
must be level. Adjust the convection mantle with the
four adjustment bolts and fasten it to the bottom of the
fireplace (B).
- Mount the clips in the four holes of the convection
mantle (if necessary, press them in place with a screw
driver (E)).
-
Press the trim in place.
-
Push the insert into the mantle and adjust according to
sketch C.
- Take out the ceramic smoke deflector plates (see next
page).
- Pull down the connection piece and place it in the
flue outlet of the insert. Fasten it with the fittings and
remount the ceramic smoke deflectors (D).
SCAN DSA 6 & 7-5
You have chosen a product from one of Europe's leading manu-
facturers of wood-burning stoves. We are convinced that your
insert will be to your full satisfaction and give you many hours of
pleasure if you follow the advice and instructions of this manual.
Please read this manual as well as the
General Instructions for
Installation
before beginning the installation.
Congratulations on your new SCAN insert!
E
D
C
A
B
Mounting of the insert in an open
fireplace
Before beginning the mounting, it is important that you check
the density of your chimney. The area of the chimney must
be min. 175 cm2, which corresponds to a diameter of approx.
150 mm.
Follow the pictures point per point , when mounting your
insert. If you have any questions or uncertainties, your
authorised dealer will be able to assist you with the mount-
ing.
Scan A/S abdicate responsibility for the installa-
tion.
