SCAN DSA 12, Сборка и инструкция по эксплуатации

Страница: 13 / 20

I N ST R U C T I O N F O R U S E
Primary air
The primary air regulation mechanism is used for lighting the fire, or
to boost the burning process when you put wood on. The primary air
vent can be 0-50% open if you use hard wood fuel such as oak and
beech. You can close the primary air vent if you use soft wood such
as birch or pine for fuel.
Settings for normal load: 0 - 50%
Secondary air
Secondary air is pre-heated and fed indirectly to the fire. At the same
time, the secondary airflow cleans the glass pane to avoid soot build-
up. If you over-restrict the secondary airflow, soot can build up on the
glass pane. The secondary airflow determines the heat output from
your wood stove.
Settings for normal load: 40 - 70%
Ash drawer
Open the glass door to access the ash drawer which is located below
the combustion chamber.
Keep the ash drawer closed at all times when the wood stove is lit.
The ash drawer must not be overfilled and must therefore be emp-
tied at regular intervals.
NAVN:
STI:
DIMENSION:
MATERIALE:
DATO: SIGN:
Krog Iversen & Co A/S
DK-5492 Vissenbjerg©
TG.NR: EMNE:
C:\Working Folder\Designs\DSA 12\90085005.idw
90085005
Brændkammer, spjæld og askeskuffe
09-06-2011 BC
Scan DSA 12
VÆGT:
AREAL:
N/A
N/A
NAVN:
STI:
DIMENSION:
MATERIALE: DATO: SIGN:
Krog Iversen & Co A/S
DK-5492 Vissenbjerg©
TG.NR: EMNE:
C:\Working Folder\Designs\DSA 12\90085005.idw
90085005
Brændkammer, spjæld og askeskuffe
09-06-2011 BC
Scan DSA 12
VÆGT:
AREAL:
N/A
N/A
CB-technique (Clean Burning)
The stove is equipped with the clean burning technique. In order to
ensure an optimal combustion of released gases under the incinera-
tion process, air will pass through a specially developed canal system.
The heated air is led into the combustion chamber through the small
holes at the rear of the burn chamber.
This air volume is controlled by the combustion rate and thus cannot
be regulated.
Lower baffle plate
The baffle plate is placed in the upper part of the combustion
chamber. This plate will block the smoke and give it a longer holding
time in the combustion chamber before it goes up the chimney. The
temperature of the flue gases will decrease because it has more time
to release heat from the stove. When sweeping, remove the smoke
deflector plate and read the "Stove maintenance" section. Be aware
that the baffle plates are made from a porous chemical material
which can break easily. You must therefore take care when handling
them. The baffle plates are wearing components and do not entail a
right to claim.
Lower baffle plate
Secondary air
0% - 100%
Adjustment of air supply,
primary and secondary damper
A
NAVN:
STI:
DIMENSION:
MATERIALE: DATO: SIGN:
Krog Iversen & Co A/S
DK-5492 Vissenbjerg©
TG.NR: EMNE:
I:\Udvikling\TEGNING\DSA 12\90085007.idw
90085007
Primær og sekundær luftregulering
21-01-10
BC
Scan DSA 12
VÆGT:
AREAL:
N/A
N/A
Pin supporting the
baffle plate
CB Technique
Primary air
Ash drawer
13