10
ASSEMBLY
TOOLS NEEDED FOR MOUNTING OF THE INSERT
¬
Spirit level
¬
Cutting nippers
¬
Cross tip screwdriver
¬
Flat head screwdriver
¬
Ø10 wall drill
¬
Open-end spanner
LOOSE PARTS
The trim is delivered on the wood pallet together with the insert.
In the insert’s combustion chamber you will find the following loose parts
¬
Bricks for the bottom of the burn chamber
¬
Log guard
¬
Glove
¬
Bag containing loose parts:
4 x self-tapping screws 4.2 x 6.5 mm
8 x 3 mm black self-adhesive gasket (2 m)
(for fastening the sleeve Ø100 mm)
(Ø100 mm sleeve, connecting piece and cassette)
4 x rawlplugs10 x 50 mm (for fastening the cassette)
4 x torx screws M6 x 50 (for fastening the cassette)
4 x discs Ø6.5 / Ø16 x 1.1 (for fastening the cassette)
Torx key T30
Ø100
mm
sleeve
with
flange
Combustion chamber package contains:
¬
Baffle plates
¬
Burn chamber plates (side and rear)
¬
3 pins Ø6 x 40 mm
ADDITIONAL ACCESSORIES
¬
Convection adaptors Ø149 mm (see page 21)
¬
Convection grates (See page 27)
DISPOSAL OF PACKAGING
Your Scan built-in stove may come supplied with the following packaging:
Wood packaging
The wood packaging can be reused and after final use can be incinerated as a CO
2
neutral
product or sent for recycling.
Polystyrene top
Send for recycling or waste disposal.
Foam
Send for recycling or waste disposal.
Plastic bags
Send for recycling or waste disposal.
Stretch/plastic film
Send for recycling or waste disposal.
LOAD-BEARING FOUNDATION
All items in our product range come under the category of lightweight fireplaces and stoves and do not normally require any
reinforcement of the beam structure. They can be positioned on ordinary beams/floor.
You should of course make sure that the foundation on which the stove is positioned can indeed support the weight of the stove
and, where applicable, a steel chimney, if you have opted for this solution. In case of doubt about the carrying capacity of the
floor, please consult a building expert.
