e
Nod3-
C
Digital Transmitter
e
Nod3-
C
:
User’s instructions
NU-eNod3C-E-0911_165702-I
11/22
4
USE IN LEGAL FOR TRADE APPLICATIONS :
4.1 Introduction
e
Nod3-
is a module making a part of an instrument. It is intended to be integrated :
-
In a non automatic weighing instrument (
NAWI
) or
-
In an automatic weighing instrument (
AWI
) of category catchweigher.
4.2 Legal for trade parameters
See relative sections in the following documents :
-
ModBus RTU communication
Ref. 165704
§ 2.11 Metrological version number
§ 2.12 Legal for trade
§ 2.37 Status register
-
SCMBus communication
ref. 165706
§ 4.3 Legal for trade settings
§ 1.4 Status bytes
-
CANOpen® communication protocol
Ref. 165708
§ 3.2.16 Legal for trade switch
§ 3.2.17 Legal for trade indicators
§ 3.2.32 Current measurement
§ 3.2.33 Current measurement status
4.3 Sealing
The module
e
Nod3-
C
has a physical sealing device and a software sealing device.
4.3.1
Physical sealing :
The physical sealing is the one of the module box. It comprises two self-adhesive stickers self-
destructive when removed or a device with sealing screws with lead and sealing wire.
4.3.2
Software sealing :
On the whole weighing instrument the value of the event counter as well as the CRC value may be
displayed.
The whole weighing instrument has a marking area where the values of the event counter and of
the CRC recorded after the last official verification.These marked values shall be identical to these
displayed on the terminal. When these values do not match, this part of the sealing device is
considered as broken.
4.4 Specific requirements :
The legal metrological software version may be displayed on the terminal.
There are also some characteristics in the status related to measurements that need to be
displayed on the terminal too.
Sealing with self-adhesive stickers self-
destructive when removed put on 2
opposite sides of the box, with a part on
the top and a part on the side of the box.
Sealing with lead and sealing wire, 2
opposite screws have to be sealed.
