Scag Power Equipment V-TIDE II, Руководство оператора

Страница: 31 / 87

27
R
Section 6
ADJUST HERE
ADJUST HERE
LOOSEN HERE
Figure 6-3. Cutter Deck Level Adjustment
2. Turn the adjustment bolts on the front and rear deck
level links clockwise until the cutter deck is level
between both sides. See Figure 6-3.
3. Tighten the two (2) elastic stop nuts to secure the
cutter deck in the proper position.
CUTTER DECK PITCH
The pitch of the cutter deck should be equal between the front
and rear of the cutter deck for proper cutting performance. To
check for proper deck pitch, be sure that the mower is on a
flat, level surface and the tires are properly inflated.
Check the distance from the top of the cutter deck to the floor
at the rear RH side of the cutter deck directly behind the cutter
deck hanging chains. Next check the distance from the top of
the cutter deck to the floor at the front RH side of the cutter
deck directly in front of the cutter deck hanging chains. The
measurement at the front of the cutter deck should be the
same as the rear of the deck. Make these measurements at
the LH side of the cutter deck also. If the measurement at
the front of the deck is not the same, the cutter deck pitch
must be adjusted as follows:
1. Loosen the elastic stop nuts securing the deck level
links on the front of the cutter deck on both sides. See
Figure 6-4 and 6-5.
ADJUST HERE
LOOSEN HERE
Figure 6-4. Cutter Deck Pitch Adjustment
2. Turn the adjustment bolts on both sides either
clockwise to raise or counter-clockwise to lower the
front of the cutter deck until the measurements are
equal. Tighten the elastic stop nuts.
ADJUST HERE
LOOSEN HERE
Figure 6-5. Cutter Deck Pitch Adjustment