10
/
10
SC POWER – SCB90Pro24
For Jump Start
Automatic cut off
3 sec. per Crank
Crank per fully charged
10 Cranks
Suitable for up to 13,000cc diesel engine.
For Charging unit (AC & DC In-‐Car Charger are included)
AC Adapter Input
100~240Vac 50/60Hz
AC Adapter Output
24Vdc 0.5A Max.
DC Charger Input
10 – 30Vdc
DC Charger output
24Vdc 0.5A
Operating Temperature: -‐20 to + 45
Recommendation:
l
In case the extremely cold temperature is forecasted, please keep the device to be charged over-‐night in order to
make sure the battery is fully charged. In case the ambient temperature is under -‐10 , it is recommended to
connect the battery for 3 minutes before jump start attempt.
Further, we recommended that you connect the
clips to disabled vehicle battery and turn the POWER on, then activate the JUMP START feature by depressing the
Jump Start button (JUMP START red light on), then wait for 3-‐4 minutes prior to cranking the vehicle. This will help
activate or “warm” the disabled vehicle battery for best possible results.
l
In some occasion, car engine may not be easier to start at first crank, so you are recommended to take several
attempts (not more than 10 times), as far as the inside battery has been warmed up, it can help to enhance the
battery’s performance.
l
In order to keep the better performance of the device, it is recommended to recharge it every 3 months, or it
ought to be refreshed at least one time within 6 months. If battery is not recharged fully after use and also
regularly maintained in a charged state at intervals stated above, then the device will not operate effectively if
battery storage conditions were not followed as battery stored in discharged state will deteriorate quickly.
l
The device will be protected at the extremely hot circumstances, so it is not recommended to store inside the car
compartment during the summer time, and not to be recharged at higher ambient temperature. (Please refer to
page 4 at point 4 of this user manual).
