SBI AC02582 Скачать руководство пользователя страница 3

Страница: 3 / 12

6. Release the fl exible hose from the air intake duct. A Small

amount of ash may be generated so be carefull (see 6

following).

7. Verify ash is cold! Allow to cool further if needed, then dump

debris. Ash is a great garden supplement!

Every 3 to 5 uses, clean HEPA fi lter while outside and away

from valuables. Screw off the fi lter wing nut and HEPA seal

plate (not shown). Take the fi lter out for cleaning (see step

below) or change. Follow the three steps below for taking off

the fi lter.

9. Cleaning fi lter - to limit dust place HEPA fi lter inside a plastic

bag (not included). To clean fi lter, tap gently against a hard

surface. Empty plastic bag and inspect fi lter. Dust within

the fi lter pleats may require gentle fl exing of the fi lter by

squeezing the fi lter’s rubber seals so as to make the fi lter oval

instead of round. Tap fi lter while “Out of round” to get deeply

set dust out of pleats.

Follow steps below for re-assembly of the fi lter :

10.

IMPORTANT

- with fi lter installed and lid in place turn

vacuum on at a dry outside location to test fi lter seal. Look

for dust at the exhaust port. A small amount is normal after

cleaning fi lter. Vacuum up a small amount of ash while still

outside to give fi nal assurance of a good seal and to verify

fi lter integrity. Replace fi lter if dust passes though at this point.

INSTRUCTIONS FOR USE

IMPORTANT NOTES:

* Each use, verify that HEPA fi lter is in place and that HEPA seal plate

wing nut is tight. Always test seal by vacuuming up a small amount of

ash while located away from living areas

** Do not attempt to use vac to remove large piles of ash from a fi replace

or wood stove. Instead remove bulk of ash with a shovel and ash can

(or hod) and then use the ash vac for fi nal cleanup.

1. Plug cord into outlet, (see photo 1 bellow).

2. Press the on/off button to switch the appliance on (see photo

2 bellow).

3. For fi replaces and wood burning stoves see “important

note **”, above. Place nozzle in fi rebox. Keep nozzle pressed

against the fl at surfaces of stove or fi replace to limit entrance

of large chunks into pickup tube. Use the built-in vibrating

fi lter cleaning feature after approximately each 1 cup of ash

is removed or when suction is reduced. Shaker instructions

are below. If large chunks are picked up, turn off machine to

dislodge.

HOW TO USE THE BUILT-IN VIBRATING FILTER CLEANING

FEATURE

When the suction is reduced or after about 1 cup of ash has been

removed use the vibration knob to help remove ash from fi lter

without taking off  the lid.
A.   Turn off  machine!
B. Hold can down and retract shake off  knob fully.
C. Release so knob bangs top lid.
D. This will send vibrations through the top lid to the fi lter to

help clear debris. Repeat 5 to 10 times. Suction should now

improve at star-tup.

4. When fi nished cleaning turn switch off , photo (see photo 4

following) .

5. Remove the plug from the outlet (see 5 following) and take

vacuum to an outside location away from valuables and

breezes.

6. Do not pull or carry by cord, use cord as a handle, close lid

on cord, or pull cord around sharp edges or corners. Do not

run vacuum cleaner over cord. Keep cord away from heated

surfaces.

7. When you want to pull the plug from the wall contact, please

do this at the plug itself and not by means of the electrical

cable.

8. Do not handle plug or vacuum cleaner with wet hands.

9. Do not put any object into openings. Do not use with any

opening blocked. Keep exhaust free of dust, lint, hair and

anything that may reduce airfl ow.

10. Keep hair, loose clothing, fi ngers and all parts of body away

from openings and moving parts.

11. Turn off all controls before unplugging.

12. Use extra care if used when cleaning stairs.

13. Do not use to pick up fl ammable or combustible liquids, such

as gasoline, or use in areas where they may be present.

14. Hold plug when rewinding onto cord reel. Do not allow plug

to whip when rewinding.

15. Unplug before connecting the hose.

16. Do not pick up hot embers, hot ash or anything that is burning

or smoking, such as cigarettes or matches.

17. Do not use without fi lter in place.

18. If the supply cord is damaged, it must be replaced by qualifi ed

person in order to avoid a hazard.

SAVE THESE INSTRUCTIONS

WARNING

To reduce the risk of electric shock, this vacuum

cleaner has a polarized plug (one blade is wider than the other). This plug
will fi t in a polarized outlet only one way. If the plug does not fi t fully
in the outlet, reverse the plug. If it still does not fi t, contact a qualifi ed
electrician to install the proper outlet. Do not change the plug in any way.

PRECAUTIONARY MEASURES

If the opening that sucks in the air or the suction pipe is

blocked, you should switch off the vacuum cleaner at once.

First clear the blocked substance before you attempt to start

the vacuum cleaner again.

1. Do not operate the vacuum cleaner too close to heaters and

items like radiators, cigarettes, etc.

2. Before you insert the plug into the wall contact, make sure

your hand is dry.

3. When you want to pull the plug from the wall contact, please

do this at the plug itself and not by means of the electrical

cable.

SPECIAL NOTE: THIS VACUUM’S MOTORS ARE EQUIPPED WITH THERMAL
“OVERHEAT” PROTECTION. IF THE MOTORS RUN TOO HOT THEN THEY
WILL SHUT DOWN. YOU MUST WAIT FOR MOTOR TO COOL AND UNPLUG
UNIT IN ORDER TO RE-START VACUUM. CLEANING THE FILTER WILL HELP
PREVENT A REPEAT OF THIS CONDITION.

Model #:

AC02582

Voltage

120 V

Frequency

60 Hz

Power

800 W

Max Vacuum

17 Kpa

Sound Level Max

<84 dB