14
Apply hydraulic fluid or O-ring lubricant to all O-rings and their mating surfaces to facilitate
installation. When installing an O-ring over a sharp edge, use a rolling action to avoid damage
to the O-ring.
Wherever assembled parts cause metal-to-metal contact, coat the surface with hydraulic fluid or
O-ring lubricant.
7. TECHNICAL FEATURES
8. ACCESSORIES
Accessories supplied
Accessories not supplied
Box
Dies (according application)
Oil
(
ALFLUID, HYFLUID
)
Test gauge kit (
PT29279-2
)
9. TROUBLESHOOTING GUIDE
Symptom/Problem
Possible cause
Remedy
Dies difficult to install and
remove.
Damaged die retaining housing on head
and/or ram.
File down raised/deformed section.
Loss of all resistance in pump
handles prior to completion of
crimp (blow-off).
Air in system.
Hydraulic fluid level low.
Bleed hydraulic system.
Fill hydraulic fluid reservoir.
Persistent problem with air
(even after bleeding).
Excessive pump handle travel.
To determine this, fully open pump
handles. Measure the center-to-center
distance of the handle ends. This distance
should not exceed 432 mm.
Contact with SBI
External leakage of hydraulic
fluid.
Damaged seal or gasket.
Contact with SBI.
Tool does not reach full
pressure (blow-off).
Internal hydraulic leak.
Contact with SBI.
Ram does not fully retract.
Over-filled hydraulic fluid reservoir.
Damaged ram return spring.
Ram wiper ring/piston contaminated.
Consult Maintenance chapter
“Replacing hydraulic fluid”
10. GUARANTEE
The Y35 and Y35BH tool are guaranteed free of defects in material and workmanship for a period of
one year from the date of purchase. Any defect that show up within one year will be repaired or
replaced free of charge. As long as the tool was correctly used following the SBI’s instructions.
After one year the units will be repaired in the factory and billed to the customer. The Y35/Y35BH tool
which has to be repaired (re-constructed in the factory, equipped with new spare parts, adjusted and
completely re-conditioned has to be sent (WITHOUT DIES) to SBI.
Together with the unit for repair, a repair order and a short description of the failure is required. AII
Y35/Y35BH toots re-constructed in the factory carry a new guarantee of six (6) months as from the
date of leaving the factory
Terminals / splices
Crimp
Section
(mm
2
)
10 - 300
10 - 300
Terminals and tubular splices
YAV – YSV – YSM – YCA - YCS
10 - 300
“C” type tap off connectors of Cu
10 - 150
“C” type tap off connectors of Al
10 - 150
Y35 Technical features
Force developed
120 kN
Length Y35
Length Y35BH
575
mm
234
mm
Weight Y35
Weight Y35BH
6
kg
3.6
kg
Rotatory head
180 º
Jaw opening
24 mm
Head width
70 mm
