![SBG Systems Exinox Subsea Series Скачать руководство пользователя страница 26](http://html1.mh-extra.com/html/sbg-systems/exinox-subsea-series/exinox-subsea-series_hardware-manual_1205153026.webp)
Ekinox Subsea
– Hardware Manual
EKINOXSUBSEAHM.1.4
4.3.3. GNSS connection in RS-232 mode
For this typical connection, a shielded AWG 26 cable should be used. Depending on PPS signal strength, we
do not recommend this cable to measure more than a few meters. For long distance, PPS signal and GPS
NMEA signals should be separated in two cables for better noise immunity.
4.3.4. Triggering external devices with the sync Out
Consider a camera that must take a picture when an event is provided on Event Out pin. Event Out and Sync
Out are “open drain” outputs, which means a pull up resistor must be used on receiver side, as shown on the
diagram.
26/42
Figure 4.4: Typical wiring diagram for Ekinox M / U with external GNSS receiver
Ekinox
GND
PORT B Sync
PORT B Rx
GPS
GPS Tx
PPS
GND
Figure 4.5: Sync Out connection with pull up resistor
Ekinox
GND
Event Out
Camera
Event In
GND
R
VCC < 20V
Pull up resistor must be connected
to Event Out to define High level
Содержание Exinox Subsea Series
Страница 5: ...Ekinox Subsea Hardware Manual EKINOXSUBSEAHM 1 4 7 5 3 4 Cable wiring 42 5 42 ...
Страница 9: ...Ekinox Subsea Hardware Manual EKINOXSUBSEAHM 1 4 Orthogonality 0 03 9 42 ...
Страница 16: ...Ekinox Subsea Hardware Manual EKINOXSUBSEAHM 1 4 3 2 2 Top view 16 42 70 89 87 109 4 HOLES 5 50 70 89 ...
Страница 19: ...Ekinox Subsea Hardware Manual EKINOXSUBSEAHM 1 4 3 3 2 Top view 19 42 75 94 75 94 4 HOLES 5 50 116 92 ...