Q.RCU-A-xxxx Series
Analog room control unit
Hardware Installation Guide
Document 26-605 | Edition ENG01 | 2016-03-22
Product Description
The Q.RCU-A-T series of analog wall sensors is designed to interface
with controllers of fan coil, heat pump, roof top and terminal
heating / cooling units. These sensors provide precision local
temperature measurement with the capability of local setpoint
adjustment, fan speed setting, and occupancy override.
The Q.RCU-A-T’s modern, alluring profile enclosure is suitable
for classrooms, hotels, executive areas, office spaces and other
commercial areas. Mounting hardware with a separate sub-base
is provided with the device for installation on a dry wall or on an
electrical junction box.
This document describes the hardware installation procedures for
the following device models: Q.RCU-A-T, Q.RCU-A-TO, Q.RCU-A-TS,
Q.RCU-A-TSO, and Q.RCU-A-TSOF.
Unless otherwise indicated, the term Q.RCU-A-xxxx will be used in
this document to represent all the models of the Q.RCU-A-T Series
General Installation Requirements
For proper installation and subsequent operation of the Q.RCU-A-T,
pay special attention to the following recommendations:
-
Upon unpacking the product, inspect the contents of the car-
ton for shipping damages. Do not install damaged sensors.
-
Allow for proper clearance of device enclosure and wiring
terminals for easy access, hardware configuration and main
-
tenance.
-
The device is designed to operate under the following envi-
ronmental conditions:
■
Ambient temperature from 0°C to 50°C
■
Relative humidity from 0% to 90%, non-condensing.
-
Ensure proper ventilation of device and avoid areas where
corroding, deteriorating or explosive vapors, fumes or gases
may be present. The device must be oriented with the ventila-
tion slots towards the top to permit proper heat dissipation.
Any type of modification to any SBC product will void the
product’s warranty.
Take reasonable precautions to prevent electrostatic
discharges to the device when installing, servicing or
operating it. Discharge accumulated static electricity by
touching one’s hand to a securely grounded object be-
fore working with the device.
