PRODUCT MANUAL
Wireless DVR : SB-WDVR50
Page 19
www.SafetyBasement.com Phone: 877-345-2336 Fax: 888-236-2524
TESTING YOUR WIRED CAMERA
Before you make any changes to the
CHANNEL SETTINGS, you should test
your camera feed.
For a wired camera, plug the AV cable into
your DVR’s AV INPUT jack.
Connect your camera to the RCA jacks.
The DVR can provide power to your video
source. The output voltage is 3.6 - 4.2 V.
When connected to a wired camera, using the AV jack, the DVR will automatically show
the camera feed from the AV Input. Wireless cameras will NOT be available to you in this
mode.
Please refer to the section about RECORDING for instruction on how to record video and
take photos.
If you are using WIRELESS cameras, please remove the AV cable from the DVR.
If you do not see an image from your camera, recheck your connections, check the power
requirements of your camera. You can also turn your DVR OFF, then back on.
The AV INPUT is automatically chosen when a proper signal is found. There are no
adjustments to be made in the SETTINGS menus.
