Instruction leaflet
Sight Twin Spot
72643
Live Voltages may be present in this unit even when turned of or when completely disconnected.
For your safety, always switch off the power supply before changing lightbulbs, or cleaning.
This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
Safety information
Cleaning Information
wash
with warm water or just use a damp cloth.
finish.
Check with your Local Authority or retailer for recycling advice.
Recycling advice
This bulbs are protected by shades. This part must be replaced immediately should the shades
become cracked or damaged. This fitting must not be used without the shades in place.
lit for the three hour period, a new battery pack may be
required.
fully discharge then reconnect to supply and allow to
charge for 24 hours.
change the battery pack as follows:
lift panel away from fitting. Keep screws safe for refitting
later.
PCB. Remove any cable ties around the cables.
safe for refitting later) and remove the battery pack.
household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling
advice.
3.6V 6000mAh Ni-Cd ONLY.
by refitting the retaining bar with the 2 screws set aside
earlier.
Battery Replacement
Fitting/replacing bulbs
V2 14/02/2020
WWW.saxbylighting.com
Saxby lighting. BH17 7BY
Replace Cracked Shade
