Instruction leaflet
Canon PIR Wall
EL-40062
(57337)
, EL-40063
(57338)
www.saxbylighting.com
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
Safety information
Saxby Lighting Ltd. LS9 0SE
This bulb is protected by a shade. This part must be replaced immediately should the shade become
cracked or damaged. This fitting must not be used without the shade in place.
Replace Cracked
Shade
Iss.2 05082015
When changing a bulb, always switch off at the mains and
allow the bulb to cool before handling. Dispose of used
bulbs carefully. Do not exceed the wattage stated or use a
different shape bulb from that indicated on the fitting.
Fitting/replacing bulbs
Care and Cleaning
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Recycling advice
Do not use solvents or abrasive cleaners as these could
damage the finish.
In normal circumstances, stainless steel is very resistant to
corrosion. It does however require maintenance to preserve
the high quality appearance. Wash the product with warm
soapy water, removing all surface deposits. Rinse with clear
water and with a soft cloth, wipe dry.
In some cases, surface corrosion may arise after installation.
This is normally caused by tiny iron particles left behind
after the brushing process when finishing.
Wash and dry as detailed above. Then with a soft cloth
soaked with a protective oil, wipe all over.
However if the product is subject to extreme environmental
conditions such as marine locations, industrial pollution
and acid rain these maintenance procedures should be
carried out around four times a year. For severe corrosion,
non-abrasive cream cleaners or proprietary stainless steel
cleaners should be used to remove the corrosion. Wash and
dry as detailed above. Then with a soft cloth soaked with a
protective oil, wipe all over.
Do not clean the units with a pressure washer.
Use a soft cloth to handle bulbs,
avoid directly touching the bulbs as
this will shorten their life.
until the light level drops.
•
To adjust Time On.
By adjusting the timer dial, the unit
will stay on (once activated) from 5 seconds to 5 minutes.
•
To adjust range level:
By adjusting the Range level dial,
the unit will activate from 4 metres to 8 metres. The angle of
detection is approximately 110°.
•
To adjust the light level:
By adjusting the Light level dial,
the unit will activate either in daylight or at night.
• For optimum detection range a mounting height of 1.8M to
2.5M metres is recommended.
+
+
+
TIME
RANGE DAY / NIGHT
