79
TSA-SA70 OWNER’S MANUAL
3
Check the alignment between the
miter detent pin positioning locator
block and the miter detent pin in
the fence lock assembly. If they do
not align when the crosscut fence
is exactly 90 degrees relative to the
saw blade, use a 10mm wrench
to loosen the hex head bolt at the
rear end of the angle guide rail
and adjust the miter detent pin
positioning locator block until it
aligns with the miter detent pin. Re-
tighten the hex head bolt.
WITH
WITHOUT
EXTENSION WING
OR
Содержание TSA-SA70
Страница 1: ...OWNER S MANUAL LARGE SLIDING TABLE MODEL TSA SA70 ...
Страница 97: ...91 TSA SA70 OWNER S MANUAL This page is blank ...
Страница 103: ...97 TSA SA70 OWNER S MANUAL This page is blank ...