38
RT-TGP/RT-BT OWNER’S MANUAL
11
12
Lay a straight edge across the front of
the extension table so that it extends
over the top of the router table. To
adjust the height, push down or pull up
on the cast iron table and then tighten
the nuts to hold it in place. Make sure
the 36” extension table is flush with the
top of the router table and then use two
13mm wrenches to tighten the bolt and
hex nut closest to the front of the
router table.
Repeat the process at the rear of the
router table, then recheck both ends
and tighten the center bolt and hex nut.
Adjust the feet in the support legs until
they contact the ground and keep the
router table level. Then use a 13mm
wrench to tighten the hex nuts (3.2) up
against the bottoms of the support legs.
3.2
