19
RT-TGP/RT-BT OWNER’S MANUAL
Assembling and Installing the Support Legs and Power Switch
Requires:
Assembled Router Table
Components and Hardware for Power Switch and Support Legs
Phillips Head Screwdriver
5mm Hex Wrench
17mm Wrench (x2)
x2
1
Begin by assembling the two support
legs. Thread a hex nut (3.2) all the way
onto a foot (3.3), then thread the foot all
the way into the base of a support leg
(3.1). Repeat this process with another
hex nut, foot, and support leg.
The hardware for step 1 can be found in the box for the Support Legs for In-Line Router Tables
(RT-ST2).
i
If you are planning on installing your router table on the right side of your Professional Cabinet Saw, and
your 36” or 52” extension table is already installed, refer to your table saw fence manual for instructions
on how to remove the extension table and support legs. You can reuse the support legs, if you wish.
Remove the brackets from the top of the support legs. You can then skip step 1, if you have two
assembled support legs with feet.
i
3.2
3.3
3.1
