14
15 16
17
18
SawStop
®
Contractor Mobile Base
7
Installing Your Mobile Base
Fig. 11
Fig. 12
Fig. 13
11.
Locate the release lever and the M8 x 30 hex
screw and fully thread the screw into the threaded
hole in the release lever (see Fig. 11).
release
lever
12.
The release lever attaches to the foot pedal arm
of the wheel support. The release lever includes
a non-threaded hole, roughly in the middle of the
lever, that aligns with a threaded hole in the foot
pedal arm, as shown in Fig.
12
. Place the M10.5
x 14.5 wave washer over the shoulder of the M8
x 17.7 shoulder socket screw. Then insert the
shoulder socket screw through the non-threaded
hole in the release lever so that the hole fits over
the screw’s shoulder, and then thread the screw
into the hole on the foot pedal arm. Fully tighten
the screw with a 5 mm hex key.
release
lever
foot pedal arm
13. Locate the extension spring and the release
lever locking screw. Note that the screw has two
shoulders, one with a larger diameter next to the
head, and one with a smaller diameter next to the
threads. Slide one end of the extension spring over
the larger shoulder (see Fig. 13).
larger shoulder
threaded hole
non-threaded
hole
