Sawo Innova Classic 2.0, Инструкция по эксплуатации

Страница: 6 / 17

2.3 Steamer Functions
English
2.2.4 Setting Mode
Long press the toggle button to activate
setting mode. It can be used to select and
adjust the fan*, temperature, humidity* and
the session time (*not all models have all
the same features). Corresponding LEDs
will be blinking on each selected features.
Change values by pressing the up and down
buttons.
Save the settings by long pressing the
toggle button, a high beep will confirm it. If
no keys are pressed within 5 seconds, the
control unit will save the settings.
2.2.7 Cabin Light Button
Cabin light can be switched on, even when
the heater or pre-run timer are off. Short
press the button and the lights will be
switched on/off.
LED for the light indicates if the light is
switched on or off.
2.2.5 Dimmer light (optional)
When the lights are switched off, short
press the light button to activate the
dimmer.
If the lights are on and the cabin light
button is pressed for long, it will toggle the
dimmer light state. Then the cabin lights
can be adjusted with the arrow buttons
from 0% to 100%. Confirm the settings
with the toggle button.
The steamer function can only be activated
if the heater has a steamer also known as
combi heater and the steamer feature is
present on the controller. When there is no
steamer present, all the functions and
settings regarding the steamer are not
available.
Press the mode button for less than 3
seconds to activate the steamer. Once
activated, the steamer is switched on,
unless the temperature or the relative
humidity inside the sauna room is too high.
High humidity and high temperature are not
allowed, “HOT” will be displayed in the
control unit and the steamer will not be
activated.
Lock the key pad by pressing the up and
down arrow keys at the same time for more
than 5 seconds. A high beep will confirm the
activation and the deactivation.
When key lock is activated only heater on/off
and cabin light functions can be used. Toggle
button is enabled only to see actual values. If
other buttons are pressed, “----“ is shown in
the display.
Unlock the buttons by pressing up and down
arrow keys at the same time for more than 5
seconds. A high beep will confirm it.
The key lock function is set automatically if it
was activated during the previous operation.
2.2.8 Key pad lock
(to prevent unauthorised use of
control unit)
2.3.1 Steamer
2.2.6 Fan (optional)
If the model installed has a fan, its speed
can be regulated. Switch it on or off by
pressing the mode button, LED light for fan
will indicate if the fan is turned on or off.
The speed of the fan can be set in the
settings mode.
Please note: If the used heater is a Combi
with a steamer, the button needs to be
pressed for longer than 3 seconds to
activate the fan. Long press it again to turn
off the fan.
5
WALL