Sawn Craft Micro F-4D Skyray, Руководство по сборке и настройке, Страница: 10 / 21

Sawn Craft Micro F ‐ 4D Skyray Manual
Page 7 141216 Micro F ‐ 4D Skyray Manual.docx
2.3 Elevator/Elevon & Rudder Hinging
•
Parts Required:
o
Elevon (2 each)
o
Vertical Stabilizer w/Rudder
o
3.5” .024” Music Wire
o
Micro Control Horn (2 each)
o
Main Wing
or
o
Elevon (2 each)
o
Micro Control horn (2 each)
o
Main Wing
Elevator/Rudder Setup
Warning: This process involves using extremely sharp cutting blades. Care must be taken to avoid injury.
1) Lay the elevons on the table with the leading edge facing yourself and the control horn slot to the
left. Use a straight edge ruler and a hobby knife or a sanding block to cut an approximate 45° bevel
into the leading edge of the control surface. Set elevons aside.
2) Lay the vertical stabilizer on the table with the bottom facing you. Carefully crack the rudder along
the rudder line or use a straight edge ruler and a hobby knife to cut down the rudder cut line in
order to separate the rudder from the stabilizer.