7
Figure 13
Figure 14
Figure 15
11. INSTALLING THE LIGHT
KIT
NOTE:
Before starting installation,
disconnect the power by turning off the
circuit breaker or removing the fuse at fuse
box. Turning power off using the fan
switch is not sufficient to prevent electric
shock.
Step 1.
Remove the 1 of 3 screws from the
mounting plate and keep it for future use.
Loosen the other 2 screws (Do not
remove).
Step 2.
Raise and hold the light kit close to
the mounting plate and proceed to do the
wire connections. Connect the white wire
connectors from the light kit and fan,
follow the same procedure with the black
wire connectors. (Fig. 13)
Step 3.
Tuck connections neatly into
mounting plate, Place the light plate key
holes over the 2 screws previously
loosened from the mounting ring, turn
light kit until it locks in place at the narrow
section of the key holes. secure by
tightening the 2 screws previously
loosened and the one previously removed.
(Fig. 13)
12. INSTALLING THE LIGHT
BULB & GLASS SHADE
Step 1.
Install 1 x 100W (MAX.) halogen
bulb (included).
Step 2.
Raise glass shade up against the
mounting plate and secure it to fan by
turning glass clockwise until snug. Do not
overtighten. (Fig. 14)
Step 3.
Restore power and your light kit is
ready for operation.
13. INSTALLING THE
BATTERY
Install 9 volt battery (included), to prevent
damage to transmitter, remove the battery
if not used for long periods. (Fig. 15)
9 Volt Battery
Light kit
Screws
Connection
plugs
Bulb
Glass shade