CLEANING
• Remember to turn off the power when
cleaning the fan.
• Clean the Motor Housings, Decorative
Housing and Horizontal Support Bar using
a clean, soft cloth, slightly dampened, if
necessary.
• DO NOT allow water to drip on or into the fan
motor housings.
• NEVER use abrasive cleaning agents
or solvents. This may cause damage or
deterioration to the surface of the unit.
To Clean the Grills and Blades
• Remove the small Safety Screws and Nuts at
the bottom of the grills.
• Unlock the metal clips around the fan grills
and remove the front grills by lifting slightly to
detach the top alignment tab from the back
grills.
• The fan blades and grills may be cleaned with
a soft cloth, slightly dampened, if necessary.
A small, soft, clean brush, (a small paintbrush
will do), may also be used to remove dust in
hard-to-reach places.
• NEVER use abrasive cleaning agents or
solvents on the blades or grills. This may
cause damage or deterioration to the
surfaces.
• Reattach the front grills to the fans after all
parts have dried completely. To do so, secure
the top alignment tabs to the back grills. Align
the front grills against the rear grills and snap
the grill clips closed.
• Reinsert the small Safety Screws at the
bottom of the grills and secure in place with
Nuts.
• DO NOT turn the fan on until it is fully
reassembled.
