RT-2AR Operator Manual
3
WARNING
Toaster is to be used with voltage specified
on data plate only. Warranty will be void if
toaster is used with any other than voltage
specified on data plate.
ELECTRICAL INSTALLATION
The RT-2AR toaster is available in 208V and 240V models. Voltage is specified on the data plate located on the
back panel of the toaster. The RT-2AR is factory supplied with a 3” power cord terminated in a NEMA approved
plug as specified for the particular voltage. For single phase operation, select the mating receptacle to match the
plug from the electrical specification chart shown.
The circuit on which the receptacle is installed must be of adequate wiring size and sufficient capacity to meet the
requirements indicated on the toaster data plate, and in conformance with the National Electrical Code and local
electrical installation codes.
ELECTRICAL SPECIFICATIONS
Voltage
Amps
KW
Plug
Receptacle
208 20.3 4.2 6-30P
6-30R
240 17.6 4.2 6-30P
6-30R
OPERATION
The RT-2AR is equipped with two heating zones, each consisting of two heating elements. These zones are
located above and below the conveyor belt and are controlled by the two heater control knobs located on the front
of the unit.
The upper heating elements are regulated by the Upper Heat Control Knob and the lower heating elements are
regulated by the Lower Heat Control Knob. These controls can be used together for toasting both sides of a
product or independently for toasting one side of a product.
The conveyor motor is controlled by the ON/OFF switch. Conveyor
speed is regulated by the Conveyor Speed Control located above
the Upper and Lower Heat Controls.
INITIAL START-UP: After the toaster is installed, flip the ON/OFF
switch to the ON position and set the Conveyor Speed Control to
maximum speed setting (counter-clockwise until stopped).
Turn both Heat Control Knobs to #9. A 20-minute pre-heat time is required. After pre-heat period has elapsed, turn
heat control knobs to desired setting. Wait approximately 5 minutes for unit to cool down. The unit is now ready to
toast on two sides. (NOTE: See chart for guideline speed and heat settings.)
GUIDELINE AVERAGE SETTING CHART
CONVEYOR SPEED
PRODUCT
208V
240V
UPPER HEAT
LOWER HEAT
White
Bread #9
#8 #6 #9
Whole Wheat Bread
#9
#8
#5
#8
Rye
Bread
#5
#4 #4 #7
English
Muffins
#4
#3 #9 #9
Croissants
#6
#4 #3 #7
!
WARNING – HOT SURFACES ARE PRESENT. PLEASE USE CAUTION WHILE OPERATING.
NOTE
To avoid damage to the conveyor
system, always have conveyor belt
running when heaters are working.
