Savch SEC-M500, Руководство пользователя, Страница: 8 / 63

5
Item Function Description Remark
Common function
17
Time of automatic
closing door
Set the time of automatically close door according to type of
elevator, inside calling, hall calling.
18 Nudging
If the light curtain block cause closing or opening door normally
exceeding 10 times and the nudging is open, the light curtain block
will be ignored and then nudging.
19 Open door at the level
Under the normally running, during closing door, if user press the
level is effective, the action of closing will turn to open.
20
Open door when stop
at level
The elevator stops and the door opens automatically at the
permitted floor.
21
Repetition of door
opening
When opening fails, it will close and then open again. Repeat this
actions, till 6 times.
22
Repetition of door
closing
When closing fails, it will open and then close again. Repeat this
actions, till 6 times.
23
Closing button for
door-closing in
advance
If it exceeds the door opening protection time, users can press
closing button to close door in advance.
24 Driver operation
The functions of driver operation state is as below: signal
orientation, driver selection orientation, without automatic close
door, by pass function and so on.
25 VIP operation
When VIP operation, the elevator can not response to hall calling
and only for one target floor in each operation.
26 History fault record It recorded 20 faults, including fault content, time and so on.
Firefighting and safety
27 Firemen operation
When fire mode back to base floor, firemen operation do not
response to hall calling and only response to one command in car
once. When close door under firemen state, please press door
open longer to limit, otherwise it turns to door close automatically.
28
Low speed self-rescue
function
When the elevator is in a state of non-maintenance, and does not
stop at the leveling, if it meets the safety requirements to run, the
lift will automatically run slowly to the nearest floor area, and then
open the door.
29 Maintenance reminder
Maintenance reminder can be setted according to times or time
operation. When the running time reaches to maintenance setted,
it will enter lock state and remind.
30 Elevator-locking
In automatically run state, after the elevator locked, the system
eliminates all calls registered. When the lock switch has been reset
the elevator re-entered to normal service state.